(800) 853-2651
SHOP NOW

IH 300 Utility PTO not spinning

M

Mwheeler23

New User
I have an IH 300 Utility, I just recently replaced the torque amplifier and got the tractor back up and running. I noticed once I put my brush hog on that the PTO shaft does not spin in any gear or neutral, no matter if it's engaged or disengaged. I am hoping i do not have to split the tractor again.

I also have an issue with my 5th gear, if I put the shifter in 5th gear it will cause the tractot to not run in any gear and when in neutral is moving forward.
 
If you have an IPTO with lever on the right, the drive gears for it are in the same area as the TA
system. Shown in the diagram. There is also a possibility that the seasonal disconnect is not coupled.
(also in the diagram) Some 300 U had that feature.
It could be as simple as a key sheared on the PTO drive shaft.
The 5th gear issue may be connected to the PTO issue if the trans input shaft is not correctly
positioned. Jim
PTO drive
 
I finally got the PTO to engage but I had to spin the shaft around till it got into a certain position than the lever would finally go up. Also the lever is ok the left side of the tractor. I know there is still something wrong with it.
 
For the 5th gear, even if the PTO is disengaged it could still lead to being the PTO issue? Could it have something to do with the allignment under the shifter?
 
To get the PTO in gear, pull up on the control, and feather the clutch out till it snaps up. The in out
mechanism is a dog clutch, and has only two places to actually engage.
The 5th gear issue could be the shifter lever being out of the rail slots, or a bent 4th/5th shifting
fork. Pulling the lever out may be the answer. Jim
 
You must log in or register to reply here.

Similar threads

S
300 Utility What is it?
Replies
4
Views
274
used red MN
U
S
My new to me 300 U
Replies
3
Views
242
Janicholson
Janicholson
P
international 300 utility tractor pto seal
Replies
4
Views
297
D Slater
D
H
1955 Utility 300 for sale
Replies
2
Views
251
redforlife
R
B
Steering wheel removal on IH Utility 300
Replies
7
Views
313
Brithorn
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top