TheRedState
New User
does anybody have a diagram on how the hydraulic cylinders are recommended to be plugged into the tractor (H, belly pump). Thanks.
- Thread starter TheRedState
- Start date
Janicholson
Well-known Member
Front left hydraulic elbow to left lift cylinder
right hydraulic elbow to right lift cylinder
single hose to each from the elbows. Do not use the left rear elbow.
The front elbows are "T"ed together inside and act like a "T" in the line.
if the lift cylinders have ports on both ends, the top ports where the ram comes out needs a vent/filter to keep out dirt.
If the cylinders are too big for the volume of the reservoir, the upper cylinder ports can be "T"ed together and attached to the bottom of the reservoir in the drain plug with a T used to still accomodate draining it there as well. This increases the capacity to allow full lifting if needed. Jim
right hydraulic elbow to right lift cylinder
single hose to each from the elbows. Do not use the left rear elbow.
The front elbows are "T"ed together inside and act like a "T" in the line.
if the lift cylinders have ports on both ends, the top ports where the ram comes out needs a vent/filter to keep out dirt.
If the cylinders are too big for the volume of the reservoir, the upper cylinder ports can be "T"ed together and attached to the bottom of the reservoir in the drain plug with a T used to still accomodate draining it there as well. This increases the capacity to allow full lifting if needed. Jim
rustyfarmall
Well-known Member
I have a #31 on an H. I recommend that you DO use hoses off the top ports, "TEE" them together and attach with a pipe union at the belly pump fill pipe.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy