(800) 853-2651
SHOP NOW

Farmall H help

M

Mlcase

New User
Hi all!

I've had this 41 H for years now. I'm just getting to all the oil leaks and tighting things up when i came across a broken transmission case. The broken piece is not in the trans so it could have happened a long time ago. Ive used it with no problems, the only reason I now about it is through visual inspection. I don't know what to do now? Should I leave it be or find a new case? Any advice will be greatly appreciated.


I uploaded a photo of the broken bearing retainer
Mike
39749.jpg
 
With top already off, think I would replace the differential bearing carrier bull pinion housing. Someone probably tried to remove housing without moving the bull gear out of the way.
Can't argue with doing okay after 41 years though.
 

Thanks for the reply! I just looked through my parts manuel then jumped on the EBAY ones on its way!
 
Those teeth on the bull gear look worn to me. look at the non drive side of a sample of teeth and compare them to the driven side visible in the picture. Jim
 
If you do find excessive wear on the current drive side of the bull gear when comparing to the coast side as pointed out by Jim N. The trick is to swap both the bull pinions and bull gears to the opposite side of the tractor. Then going "forward" you are using the current coast side of the gears. In most cases especially parade and show use the gears will last a long time after being swapped. The photo is not as good as looking at it in person, but looking at the wear I see on those teeth if you have not looked closely at the bull pinion and inner axle bearings on that side I would strongly suggest it. It sounds like you at least will be swapping that carrier so you will be right at those bearing on the bull pinion anyway. Hope I'm not "preaching to the chior"
 
You must log in or register to reply here.

Similar threads

R
Looking for complete belly pump assembly for 1940 Farmall H serial H21044
Replies
8
Views
439
BarnyardEngineering
BarnyardEngineering
G
Farmall H C152 piston ring help
Replies
11
Views
360
Highwayman
H
3
Sticky valve s on 48 H Farmall
Replies
16
Views
884
Duner Wi
D
C
1953 Super H water in oil
2
Replies
25
Views
1K
used red MN
U
F
1950 Farmall H Estate Buy
Replies
9
Views
403
Farm Boys Way
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top