(quoted from post at 15:29:00 05/07/16) unsnap the 2 clips and the cover will slide ahead. then i would spray some wd40 in there to loosen the lever up. then oil it. must be just sticky i would think.
I could but the front one needs some work, possibly stuck starter valves?? On diesel it only runs on 2 cyl.(quoted from post at 08:24:13 05/08/16) why couldnt you start the second one by just driving the tractor with the one engine?
Moose Jaw Saskatchewan(quoted from post at 09:17:29 05/08/16) Where is this sale located?
Ya, we'll see how I'm doing for time getting everything ready. There's also a car show/shine going on that Saturday that i would like to take my 67 C10 to, but we'll see what happens. The guy that bought that one with TD18 engine in it will have it in pulls I'm sure, I'd like to see that.(quoted from post at 10:07:05 05/14/16) you need to take some of those 40's and give them a work out.
Ya it runs great.(quoted from post at 13:33:03 05/23/16) does it run? i see it has the same block under the seat like mine.
(quoted from post at 15:35:09 05/23/16) whats the pully for on thr front and does it have a pto..........knee deep in rubber nice tractor..........dewy
July 18th near Moose Jaw, Saskatewan. Look at the original post there is a web address for photobucket & auctioneer(quoted from post at 19:00:38 05/24/16) When is the auction and where? They seem like some pretty solid old McCormicks
I don't have any W9's, I hope to have a WD9 running. I have good spark at coil wire but nothing at plug wires, hope to get back to it tomorrow.(quoted from post at 04:58:05 07/14/16) Do you have a w9 running ? When where is
your auction?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy