(800) 853-2651
SHOP NOW

Farmall 113 engine

G

gidtex

Member
Done some checking on internet about problem
with loose fitting piston sleeves.the block
is stamped faam,block date code 8-30-W.which
i believe is 1952 super a.they claims on
another site that super a built after 1951
will accept 3.250 overbore kit.i got about
about .060 clearance per side betwwen sleeve
and bottom bore.
 
"W" is 1951. Sounds like you have the later block. In any case, you need to check the part number cast in the block.
 
What does it measure at the 0-ring area thats the answer. What did the old sleeves measure in that area. Different bores will fit that block also
 
I have a friend that just purchased a 1940 A that has a newer Super A block with no serial number stamped.

I suspect the original block was broken and the a new one was purchased from the dealer (lack of serial number). You never know what could have happened to these tractors in their life times!

K
 
You must log in or register to reply here.

Similar threads

D
113 engine
Replies
4
Views
527
gene bender
G
F
Identifying farmall super M
Replies
3
Views
1K
steve_in_mo
S
K
Is this a C113 or a C123 Engine?
Replies
8
Views
2K
mkirsch
M
J
Boring out Farmall M Engine Block
Replies
5
Views
2K
JBlavl
J
E
Engine SN/Date Code
Replies
5
Views
2K
CNKS
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top