CASE 610 TERRAMATIC Drive

FredR · Apr 21, 2018

I am restoring a CASE 610 Terramatic Drive diesel. The last parts that I need are the leaf springs. I can get the made easy enough, but wht I am needing is the dimentions of the spring arch. I have the number and leanght and width, but not the arch.
If anybody knows what this would be that would be great. The CASE 600 loader crawler will be the same. I know a few folks on the forum have that machine.
Thank you.
Fred

TGP · Apr 22, 2018

Hi Fred,

The springs are pretty flat.
Best I could measure by raising the front of the crawler to
relax the spring was one inch from the center of the bottom
Leaf at the center bolt, to a straight edge across the ends of the pack front to rear.
Make sense?
There are 7 leaves in mine.

FredR · Apr 22, 2018

Ijust replied to your other post in the CASE section! I seen that one first. Yes, that makes sense. Does your crawler still sit fairly level? I wonder how much "spring" has been relaxed over the years. My 610 has a 2000 lb counterweight on the nose of the
machine, that might be a little more weight than a dozer when it's lifted, maybe??
Thanks for maesuring that for me, it's appreciated.
Fred

CASE 610 TERRAMATIC Drive

FredR

Member

TGP

Member

FredR

Member

Similar threads