JD 450G

avant 1735 · Jan 27, 2017

I have a weldco-beales parallel ripper on my 450. The hydraulic cylinder that raises and lowers the ripper is leaking
badly. I took it off and tore it down to replace the o rings/seals. The parts catalog has nothing in it about weldco-
beales. I cant find anything on-line either. I cannot find any numbers on the cylinder, but I will look again tomorrow
with a magnifying glass. Does anyone happen to know a part number for the seals so I can order them. Thanks.

jm. · Jan 28, 2017

IF you are good at measuring and figuring out what you have you can go to BAUM iron and order any seal or part in a hydraulic cylinder, usually at a good price.

Denny K · Jan 28, 2017

jdparts shows AR105453 kit for 1 1/2" rod 2 1/2" bore cylinder for Weldco-Beales ripper cylinder. Internet priced at about $36.00. I looked up the ripper under 450G and the title on the parts page had Weldco-Beales on it.

avant 1735 · Jan 30, 2017

I am unable to find what you found. I have looked I think all over the JD parts website and the only ripper I can find is not the weldco-beales. Would you mind giving me a step by step run through to finding it. My email is [email protected] Thanks very much. If you give me your phone number I will be happy to call you as well.

Dennis K (WA) · Jan 30, 2017

Weldco Beales is still up and going but I think you will have to go through your dealer for parts. Call Deere Dealer. Should be a model number on the ripper.
A hydraulic supply co. should be able to match up the parts you need also.

JD 450G

avant 1735

Member

jm.

Well-known Member

Denny K

Member

avant 1735

Member

Dennis K (WA)

Member

Similar threads