mike crissman
Member
Oil pressure starts out at 25 pounds run for half hour drops to 2-5 pounds thinking bearings 4 cylinder diesel motor same as hd4 thanks
- Thread starter mike crissman
- Start date
I would say you are probably just about right. Age with worn bearing and a worn oil pump. You might try adding LUCAS oil tteatment and going to 15W 40 wt oil but you are risking disaster if a rod comes unwound.
Be sure and check the cam bearing IF you go into the engine.
Be sure and check the cam bearing IF you go into the engine.
mike crissman
Member
Thanks going to take motor out anybody no if u can rebuild oil or is one still available for it
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy