(800) 853-2651
SHOP NOW

900 Case

H

Hemi

Member
So I'm trying to get gearshift out of 900 case. Pictures of broken shift lever, then of both ends of pin going through shift lever, and the 2 little clips I took off that retains the pin in shift lever.
Any help on this ???

TIA: Hemi
a175400.jpg

a175402.jpg

a175403.jpg

a175404.jpg
 
Penetrating oil first, every day until the pin remover tool you ordered arrives. It should look something like a C-clamp with a hole in the stator end for the pin to go through, and instead of the usual swivel foot, a pin slightly smaller than the one you're pushing. Sort of like a chainbreaker only a bit bigger.
 
You must log in or register to reply here.

Similar threads

M
This winters 730 project
Replies
5
Views
476
Mike Fitz
M
W
MF 302 Industrial
Replies
1
Views
179
Will_Steve_NS
W
T
Case triple range hi lo range selector broke
Replies
3
Views
487
BarryfromIA
B
J
Massey Ferguson Transaxle ID questions
Replies
2
Views
419
jshea132
J
R
1170 tranny top cover reassembly problem
Replies
1
Views
321
Ron Sa
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top