Good Afternoon, I changed the fuel filter on my Case model 1835c, with the 3-cylinder diesel engine and now it won't start. I bled each injector by running the starter until fuel came out each one of them. I filled the fuel filter with fuel before I installed it but a lot of fuel drained out of the bottom holes of the filter when it took 15-20 seconds to put the filter in place and install the hold down latch. Any idea how I can get it started. I did use a little starter fluid but it still wouldn't start. I put a new group 31P battery in it too. Thanks for any advice. Thanks, Jdubya
- Thread starter JdubyaM
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy