munson1086
Member
Hi everyone,
I just put new head gaskets on the 400 - they were leaking oil down the block because of bad orings. Today I finally got the heads back on with all new gaskets and followed all instructions in service manual. All torqued to spec.
Now when I start it, it runs at about wide open and is running lean - choke is needed to run. The throttle lever has no control. It ran perfect before this job. Any suggestions?
Thanks!
Matt
I just put new head gaskets on the 400 - they were leaking oil down the block because of bad orings. Today I finally got the heads back on with all new gaskets and followed all instructions in service manual. All torqued to spec.
Now when I start it, it runs at about wide open and is running lean - choke is needed to run. The throttle lever has no control. It ran perfect before this job. Any suggestions?
Thanks!
Matt