(800) 853-2651
SHOP NOW

770 power shift gasket sealer?

P

pllr

Member
Hi all, I am getting ready to re assemble the powershift valve, been busy scraping old gasket off of top of transmission, what is recommended sealer to use? Permatex blue? or ? I found part of reason for hanging up in intermediate on power shift, C-2 was stuck, as Rod thought, C-4 was sticky, C-1 and C-3 were good,
after following Rod's tutorial for re-assembly of rp-34, I discovered someone used the heavy spring for C-4 in the C-2 pilot valve, this may be reason C-2 stuck after sitting a few years. Thanks again for all info. Greg
 
Just reinstalled my RPS34 valve body on a dry gasket except a few dabs on the outer surface of the area I needed to JB weld. Installed - tightened and left 24 hours for the gasket goo to dry. Absolutely don't want any squeezing out into the oil flow paths internally. Good luck and sounds like successful rebuild! Brian Case farm kid
 
Nothing for sealer, dry gasket, got it, last person that worked on this tractor used a black sealer, set up hard, having a bugger of a time cleaning old gasket off, I did not think I would want to take a chance on gasket maker getting into the oil passages.. will keep at it till done, Thanks!!
 
You must log in or register to reply here.

Similar threads

W
Lazy Power Shift engagement
Replies
0
Views
315
WayneJ-HT
W
W
A/C B power unit.
Replies
7
Views
708
Wheat47
W
olgentdc
Can a CASE 1070 Power shift transmission lock a engine
Replies
8
Views
743
olgentdc
olgentdc
W
A/C B power unit over heating
Replies
4
Views
744
Wheat47
W
S
Case 2094 powershift and hydraulic problem
Replies
2
Views
1K
jimvw
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top