So I have this VAC wit ha Stockton type 3 point. I have a carrier on it that I had hoped to use for deer season. So this morning one of the guys shot a 7 point buck and I took the VAC to go get it. I set the lift as for down as it goes. It goes down till it hits the swinging draw bar. So we load up the deer and I try to get it to lift but it would not lift the deer.
So now I have to figure out if it is the pump or the cylinder. Short of unhooking the hose form the cylinder and hooking up a gauge is there a way to adjust or figure out if it is the pump or the cylinder?? Neither one appear to leak any place and the cylinder is a single acting cylinder.
So now I have to figure out if it is the pump or the cylinder. Short of unhooking the hose form the cylinder and hooking up a gauge is there a way to adjust or figure out if it is the pump or the cylinder?? Neither one appear to leak any place and the cylinder is a single acting cylinder.