(800) 853-2651
SHOP NOW

Cracked head

1

13mmwrench

New User
I'm wondering if anyone has any experience with getting a caston head welded. I'm still looking for a solution to the cracked head on my 730ck since these heads seem notorious to crack. It's an a33613 casting. Is it possible to use an earlier casting that says it's for decompression?
 
I have a 1966 830 CK with no head cracking problems but also a 1967 830 CK which I bought as spares tractor which has two cracked heads.
I have been told if the engine is run without the thermostat they will crack head/s
 
I have seen them cracked by not allowing them to cool after working before shut down,, that said 730 and 930 use the same heads,, and yes a early head with decompressor will work
cnt
 

Thanks case nutty I will expand my search for a head to early ones too this tractor had a radiator leak and the previous owner seized it only cracked one head luckily and a set of new sleves will fix the bottom end
 
Where are you located, I have 3 good 930 decompressor
heads, would need valves done. I am in Windsor ontario
Ben
 
You must log in or register to reply here.

Similar threads

W
B414 cylinder head ferrule
Replies
8
Views
263
Fritz Maurer
F
A
1955 cat D7
Replies
5
Views
513
andy41372
A
J
953 gear weight capacity
Replies
0
Views
156
johndeeregreg
J
J
953 gear weight capacity
Replies
3
Views
328
coonie minnie
C
2
super 55 and 66 cylinder head the same
Replies
4
Views
464
SPMN
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top