Going to put a 2670 engine in my 930 for pulling, I've been
doing some measuring and knew this before but I have to do
some cutting to the front casting to get the front pulley and
dampener to clear, and might have to drill new holes for wide
front axle support and modify bracket. Do any of you guys
know or have done this, used a dampener from another 504,
451 or 401? It will only be used for pulling, is there a diffrence
between small and large journal pulleys and dampeners?
Thanks
Ben
doing some measuring and knew this before but I have to do
some cutting to the front casting to get the front pulley and
dampener to clear, and might have to drill new holes for wide
front axle support and modify bracket. Do any of you guys
know or have done this, used a dampener from another 504,
451 or 401? It will only be used for pulling, is there a diffrence
between small and large journal pulleys and dampeners?
Thanks
Ben