930 pulling

jon f mn · May 23, 2016

I built this tractor about 24 or 25 years ago and sold it about 18 years back. A guy from Wi bought it recently and sent me this video. The rules when I built it required a stock block and driveline and opperating pto, but the engine is bored for 504 sleeves and pistons and has 2670 heads. I had a lot of fun with it for a few years. Except for tires ot is unchanged from when I built it.
Pulling

1370rod · May 23, 2016

Looks like it is still going strong. Rod.

jicase#1 · May 23, 2016

It was a good running tractor i was there..pull was at Camp Douglas, Wi

Don Rudolph · May 23, 2016

That is one strong 930! You must have done a very good job on that motor. Don

111 · May 24, 2016

Jon, that is a nice running 930, any idea of the hp it was putting out? and what rpm it was running? I'm putting a 2670 engine in a 930 for pulling, I really like your old 930 great job
Ben

jon f mn · May 24, 2016

It runs at a bit over 3,000rpms like that and a bit over 150hp. That is no turbo. If you jump the pump one gear so you can advance the timing more it will spin up to 3500 and put out over 200hp, but with very little torque, so it lays down quick. It was spin ballanced to 3500 rpms.

01gentdc · May 25, 2016

AWESOME

930 pulling

jon f mn

Well-known Member

1370rod

Well-known Member

jicase#1

Member

Don Rudolph

Well-known Member

111

Member

jon f mn

Well-known Member

01gentdc

Well-known Member

Similar threads