conner9988, a question

Richard G. · Jan 17, 2016

I would like to have remotes on my 51 VAC with my eagle hitch.
Could you post photos of your setup showing hose connections and valve. I think I could find quite a few uses for it including putting a small cylinder on my AC 40 combine to raise and lower the header.
I also would like to have a 5 foot disc on wheels for it in addition to my 3 point disc.
Thanks very much.
Richard in NW SC

connor9988 · Jan 17, 2016

Ill get some more close up pictures here in a couple of days. We made a plate for the axle which the single remote bolts to. The lever was fabricated from a parts 730 hydraulic lever. The valve is a Prince brand if I remember correctly. The way we have it tucked between the fender and under the deck plate makes for somewhat of a tight fit. The pressure line from the pump on the engine runs into the in port on the valve and into the eagle hitch where it is dumped into the reservoir. While using the remote you cannot use the EH but that would take both hands to even attempt.

If you have any questions let me know. I hope this helps.

Richard G. · Jan 17, 2016

Thanks so much. I am sure I will have lots of questions later.
Got to finish up a couple of other projects before I start on this one.
Richard

dick benson · Jan 17, 2016

I have a CAC 1951 with after market remotes I am going to be removing if your interested. Someone added them but not a bad job. Dick.

Richard G. · Jan 18, 2016

Can you send photos? My email is always open.
Richard

conner9988, a question

Richard G.

Well-known Member

connor9988

Well-known Member

Richard G.

Well-known Member

dick benson

Member

Richard G.

Well-known Member

Similar threads