I want to switch a diesel block to lp governor set up. I need the cam, gear and all Governor parts. Anybody got anything
email. [email protected]
email. [email protected]
- Thread starter Travis M
- Start date
Travis,
I do not think that you are limited to the 6 speed cam, I believe later cams will fit, i could stand corrected on that but I think even the cranks will interchange.
Someone else may come on and correct that if I am in error and opinions are welcome, A lot of the things we run into someone else has done earlier so all info is valuable.
Mel
The 8 speed camshaft will fit, but it is a different grind. The 6 speed has a PTO engine speed of 1450 RPM, and the 8 speed is 1950. The cam grind is such that they lug the best at PTO speed. The 6 speed will lug all day at 1200 RPM, but the 8 speed falls out of bed at about 1600.
fastfarmall
Well-known Member
Did the high speed engine have a harmonic balancer then ?
jean claude marleau
Member
I do hAVE A good used CAMSHAFT GEAR and governor Lever assembly for you 930 my e mail is [email protected]
Just guessing but Travis is a weekend warrior on the pulling tracks and I seriously doubt that the stock cam specs are of much value to him. I could of course be wrong on this but i'll take my chances, He would probably have it in transit to a good performance cam grinder.
Mel
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy