munson1086
Member
Hi Everyone,
I hope everyone is doing well and that harvests are going smoothly!
I've been having terrible starting issues with the DC - finally decided to change to a distributor after I converted to 12V. So far the DC has been firing right up, with barely half a crank with the starter.
What I found when converting seemed interesting - all but one wire was burnt where they connected into the cap on the mag. I have never seen this before - what could have caused this? They were all new copper core wires. This is most likely why my starting problems were getting progressively worse.
Matt
I hope everyone is doing well and that harvests are going smoothly!
I've been having terrible starting issues with the DC - finally decided to change to a distributor after I converted to 12V. So far the DC has been firing right up, with barely half a crank with the starter.
What I found when converting seemed interesting - all but one wire was burnt where they connected into the cap on the mag. I have never seen this before - what could have caused this? They were all new copper core wires. This is most likely why my starting problems were getting progressively worse.
Matt