(800) 853-2651
SHOP NOW

Some Recent Pictures

connor9988

connor9988

Well-known Member
Location
Central Iowa
Some pictures for everyone

The bushings were the exact size as the case ones just slightly longer. We drilled the grease hole into the bushing and drove it in. It was a little tight and we had to sand it some to get it down the shaft.
the bushings were under $2.00 each online if anyone is interested.
a199765.jpg

a199766.jpg

a199767.jpg

a199768.jpg

a199769.jpg

a199770.jpg

a199771.jpg

a199772.jpg

a199773.jpg

a199774.jpg

a199775.jpg

a199776.jpg
 
Each time I see pictures of your VAC I think that you should make and sell that seat design. Normally, I like original, but that looks good and I am sure more comfortable. Anyway, nice job.
 
Thank you for the replies.
The seat was a bit of work to put together so it most likely wont ever see mass production. It does make for a better ride though.
 
I love it all - very partial to the Briggs generator. When I was a young teen I had one of those old Briggs engines. the sound of them and the ease of starting made something in my blood tingle. I have always been partial to the older slow speed engines of all sorts. This is my 1924 cement mixer when I put it back to work on my home a few years ago. Now I have to hire someone to feed it, but it gets use off and on now.
1924 Kwik Mix cement mixer back to workafter a couple years.
 
You must log in or register to reply here.

Similar threads

D
Ford NAA New Front spindles with bushings
Replies
2
Views
144
Tim PloughNman Daley RIP
T
T
1939 UTS Water-pump issues & parts
Replies
10
Views
299
Duey C
D
B
310d backhoe won't stay running under load
Replies
4
Views
200
Blake985
B
H
Update on my runaway wagon
Replies
1
Views
302
used red MN
U
K
Redneck wreath
Replies
12
Views
535
ss55
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top