1967 Case 830 CK : Question

thedawg · Apr 5, 2015

I recently purchased a 1967 Case 830 tractor. So I am not familiar with it and would like more info. I just found out the Hydraulic dipstick is indeed the breather cap located at the back of the tractor. I have tried to twist it but it will not move. Is there a trick to removing this cap? Don't want to break it. Also I am looking for an Operators manual or something on line to give me more of a tour of the tractor and location of serviceable parts and understanding of it's operation. I have never owned this age of a tractor before and I see a lot of grease nipples and want to make sure I get them all. Any help you can offer would be greatly appreciated.

[/img]

casecollectorsc · Apr 5, 2015

Transmission dipstick pulls straight up...may need to tap it to get it off. Use hy-tran if low.

Bruce from Can. · Apr 6, 2015

Nice tractor, always wanted one like that , folks near me had one when I was a boy. I got to run it a few
times,and found it would go like a cut cat down the road. They used to do custom silo filling , and the 830
sat on the blower at the silo. Man could that 830 blow corn!!

cs.hess · Apr 6, 2015

Those dipsticks can be a bear to get out especally if it was pushed in too hard..You need to tap as other person said --try to put leverage
evenly under cap .Dont get too rough an bend it!! Good idea to get muffler cap to keep rain out of engine even though Case had small hole
in manifold to allow rain to drain.d H
Also take care of that seat !
Keep it dry.

1967 Case 830 CK : Question

thedawg

New User

casecollectorsc

Well-known Member

Bruce from Can.

Well-known Member

cs.hess

Member

Similar threads