Cross motor

John Achmann · Feb 26, 2015

I've got a set of cylinder liners being made for my 18-32. The question I have is the grove for the O ring just don't jive with a regulator round O ring and don't really look like a square ring would fit, what was in from factory? Only one ring was together when I pulled the liners out and not very good to match. Thinking of maching the grove to match the round ring. Any help or suggestions will be great.

1031D · Feb 26, 2015

It's actually a large square packing and Olsen's Gaskets offers new ones.

John Achmann · Feb 27, 2015

Wonderful! I wasn't sure, parts book called it a packing. It sure
didn't look round at one time but one never knows. Thank you
for the help.

John Achmann · Feb 27, 2015

Wonderful! I wasn't sure, parts book called it a packing. It sure
didn't look round or square at one time but one never knows.
Thank you for the help. Never thought of calling olsen gaskets.

1031D · Feb 27, 2015

(quoted from post at 04:59:35 02/27/15) Wonderful! I wasn't sure, parts book called it a packing. It sure
didn't look round at one time but one never knows. Thank you
for the help.

I do have a set of NOS sleeves if you need measurements.

John Achmann · Feb 28, 2015

Thanks for the offer but we got good measurements off of the
old sleeves. The oring grove was throwing us off a little. I'll
keep you in mind if any other questions arise.

Cross motor

John Achmann

Member

1031D

Well-known Member

John Achmann

Member

John Achmann

Member

1031D

Well-known Member

John Achmann

Member

Similar threads