(800) 853-2651
SHOP NOW

Case 300 Hand Clutch adjustment

L

Larry Cauffman

New User
This message is a reply to an archived post by Joe Wa on April 30, 2012 at 15:50:40.
The original subject was "Re: Case 300 Hand Clutch adjustment".

I can not move my hand clutch over center. It was this way when I bought the tractor, a 57 Case 300. I feel the clutch is adjusted too tight for the lever to go over center. Standing on the left of the tractor and facing forward. towards the rear of the engine, which direction would I turn the clutch adjusting yoke to loosen the clutch. To the left to loosen or to the right. I would like to de-adjust the clutch till the lever would go over center, then re-adjust for the proper over center pull.
 
Larry it's been awhile but this thread should be correct. You'll be turning the main shaft with the input gear, CW to loosen facing forward, the drum remains stationary.

In any event you will know pretty quickly if you are going the right direction. It doesn't take many pin pulls to loosen the disks if the clutch was assembled correctly.

Joe
Case 300 Hand Clutch adjustment
 
Turning clockwise should loosen it. Don't forget there are 2 pins but only 1 will engage at a time.
Nick
 
You must log in or register to reply here.

Similar threads

S
695 case tractor clutch problem
Replies
6
Views
482
Texasmark
T
J
1961 CASE 530 Loader/Backhoe clutch problem
2
Replies
20
Views
1K
Jacres
J
P
90 Series case remote coupler locations??
Replies
2
Views
309
want@1070
W
C
Case 351 clutch pressure plate
Replies
0
Views
232
CaseOhio
C
A
1953 DC Case Wet Clutch? And other questions
Replies
12
Views
694
chuck machinist
chuck machinist
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top