Have the front end of my DC3 apart. Got the hand crank coupling housing out cleaned up and came up with an appropriate spring. It is now ready to go. I was hoping someone could give me the dimensions of a DC3 hand crank. Shaft diameter. distance to the first and second bend. Would be neat to have a crank for her. I have a crank for the VAC and use it occasionally to stay in practice and impress the young folk.
- Thread starter Paul f
- Start date
chuck machinist
Well-known Member
This ARCHIVE POST COMES From dc3case .Good luck Chuck
CaseDC3
Member
That guy is a fantastic artist.. It's so real I feel like i was there!!
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy