Topic: Re: Case 930 PTO clutch replacement
|Case Tractors Discussion Forum|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
|Adirondack case guy
Read your post again, and agree that there is one seperator spring for each Sinterd/Fiber plate.That said look closely at how plates are stacked from the rear retaining plate. A steel plate butts against it, then a spacer spring surounded by a sintered plate, and then a steel, etc,etc, depending on the number of plates used for each model tractor. This configuration was used from 300s to 1570s When the 70 series came out the clutch packs were actuated hydraulically, rather than mechanically. With the unit out of the tractor, you should easily be able to tighten up the pressuerplate/collar assy to a point where you feel a slight drag. Then you should be able to push the collar in part way and taking the handle of a hammer, mtunk the linkage over center. At that point you should not be able to turnthe PTO shaft without turning the whole clutch assy. also. (Warning)the 1/2" mcap screw on the intermediate jackshaft is a special bolt with a locktite compound on it. If it comes out it can get under a bullgear and crack the tranny housing, and cause problems with the grar train.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters