case 188d

spike11792 · Feb 10, 2013

I have a case 1835 skid steer with a 188d. It was running well and I got off it and I lowered it to an idle and moments latter it just suddenly stopped. It had been running for two hours at the time. It will start if I use ether but stalls when the ether runs out. Help?
also I have opened the air cap on the final fuel filter and used a compressor to pressurize the fuel tank and made sure fuel was unrestricted to the final filter.

1370rod · Feb 11, 2013

If you know you have a good supply of fuel to the pump you might check this. Remove the fitting from the top of the inj. pump that fuel bleed off line or lines are connected to. Look in the bottom of the fitting, if there is some nonmetalic material sticking in the fitting the governor ring in the pump is begining to fail. If the fitting is plugged the pump stops pumping. You can use compressed air to clear blockage and reinstall fitting and engine should run again, but pump needs repair. The problem will reoccur.

Anonymous-0 · Feb 11, 2013

well thats enuf ether for now . save it for after you change filters to aidtake up after priming ,, if it is below freeezing ,, you may have ice buildup , but that sees unlikely after 2 hours runnin ..

Anonymous-0 · Feb 11, 2013

rod ,, you may have it,,. fuel return line plugged,,

spike11792 · Feb 11, 2013

(quoted from post at 14:44:40 02/11/13) rod ,, you may have it,,. fuel return line plugged,,

Thank you so much for the help guys. I will try what you are suggesting and let you know how I make out. I hope it is just a blockage or I will be on here a lot to get help with the pump. We are under 3 ft of snow here in NY and the plows can't make it through, Murphy's Law.

case 188d

spike11792

New User

1370rod

Well-known Member

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

spike11792

New User

Similar threads