What mods? I thought the 201G used a 188G block? meL and John Saeli indicate that rebuild parts for 201G are next impossible to get. Just from a little looking, it seems 188G rebuild parts are harder to get than the 188D parts.
Re: 201g engine in reply to Jgarner, 12-19-2012 06:33:18
If the information I've recieved from a couple of guys here is correct, the combine engines had a belt-driven governor, and they won't function properly in an ag application. The engine would have to have the timing chain cover and ag governor controls put on to it. I've got a 440H with a G188D in it,(out of a combine, apparently) and it's got the belt-driven governor on it. I was told by a couple of guys here that I'd have to change the governors out for it to run right. I have a g148 that's got the pieces, but have yet to do it. There may be other things, as well. There's been several discussions on it here.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.