grandpajohn
Member
My 1070 I have been working with is acting up. I rebuilt the injection pump earlier in the year and it ran fine. Lately it seems that when it sits for a few days it doesnt want to start. I give it a shot of either and it fires right up and all seems fine. This past weekend It does not want to start it will run as long as I am giving it either but will not run. I removed the sediment bowl at the pump and fuel runs out at a very good pace. If I pump up the hand pump it will fire up and If I continue to pump it after Its running it will continue to run and sounds fine, but after a little bit it quits running again.
I am thinking its sucking air and loosing prime but when I remove the sediment bowl at the pump fuel runs freely. Does any one have any ideas where I should look?
Thanks
gramps
I am thinking its sucking air and loosing prime but when I remove the sediment bowl at the pump fuel runs freely. Does any one have any ideas where I should look?
Thanks
gramps