Axle pivot pin bushing for VAC

My early adjustable wide front pivot pin bushing on my VAC is in need of replacement. The part number is 06472-AB, which is NLA from Case. Does anyone have one for sale, or have the dimensions so I can make one?
a87237.jpg
 
I have some bushings left from when I did my 830 and 400. If you know the size I could check if I have any that size.
 
The pin measures 1.117" and doesn't appear to be worn too much, so I would think the ID of the bushing should be 1 1/8" or so. I don't know for sure because the old bushing in the axle is almost gone! There is a lot of slop around the pin! The length of the bushing is 1 1/4" - 1 1/2"
 
I'm guessing the OD to be about 1 7/16". The hole in the axle is wallowed out badly and elongated vertically. I will probably have to ream it to get a round hole again, and as near as I can tell
1 7/16" will cover the vertical measurement. This axle must have been on a loader tractor. It isn't original to my tractor.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top