WD ALLIS FRONT END

ohe · Aug 6, 2017

Reworking the front end of WD 2 wheel narrow front, need seal # for the hubs & where to get the bottom bearing of the pedestal THANKS FOR ANY HELP!!

ramblineagle · Aug 6, 2017

the only place I could find the correct pedestal bearings for my d17 was the local Agco dealer. would guess that what you need will be dealer item only.

Hoenes · Aug 7, 2017

Try searching the archives of this sub-forum, it seems like someone made a list a couple years back, of everything needed for your project. (With part numbers)

Aaron SEIA · Aug 7, 2017

Go to www.agcopartsbook.com and look up the parts book. You can find the part numbers and a GOOD supply place can cross them.
AaronSEIA

tractorguy2 · Aug 8, 2017

I tore a WD front end a part about eight years a go. There was
one bearing. And I think it was the bottom one. Was a special
Allis Chalmers bearing. The rollers were cone shaped. Allis
wanted $300 for the bearing. I searched everywhere and came up
dry. I ordered the $300 bearing. The bearing was in a warehouse
down south. I live in Nebraska. Allis Chalmers charged me $60
for freight.

Jerry Coulter · Aug 12, 2017

The bearing in the lower end of the spindle shaft was AC numbers 209933 cone and 209934 cup. But after serial #WD59987, they became 224908 cone and 224909 cup. I am thinking the earlier bearing had barrel shaped rollers and the later had cone shaped rollers. But it could be vise-versa.

The hub seal is just a felt do-nut clamped between 2 washers. An auto parts store should be able to locate a CR #596 for you.

WD ALLIS FRONT END

ohe

Member

ramblineagle

Member

Hoenes

Member

Aaron SEIA

Well-known Member

tractorguy2

Well-known Member

Jerry Coulter

Member

Similar threads