200 Starting Problems

WiJay

Member
I have an issue with my 200,The old starter died and I put in a brand new one from All States, I also installed a new ignition switch and starter button,Now when I turn on the ignition the warning light does not come on and I have no power to the ignition.
I will say electrical is something I struggle with but always willing to give it my best shot.
Are there any fuses that could cause a starting issue?
This next summer I am going to try and rewire the tractor just need to get it going for hauling rd bales to feeders.
Thanks
 
Sounds like when you installed the new starter you got one of the wires in the wrong place. I do not know that tractor as such but there should have been one wire that hooked to the battery side of the solenoid that goes to the ignition and likely you got it in the wrong place or maybe over looked it and did not hook it up at all.

Also helps if you tell us if it is gas or diesel.
 
If you have an electrical tester with a light and a super sharp probe (to penetrate the wire insulation) you can follow the wire that is supposed to have power until your tester lights up then you will know where the problem is.
 
Its a diesel, and the starter is hooked up correctly, I am thinking when I pulled the dash forward to install the new switch and starter button something got disconnected, I do have a AC shop service manual to use for reference.
 
There are two fuses in the dash, the ends twist and you can pull them out. One is for the ignition, can't remember which one. Usually able to tell by looking, but a meter will tell you for sure.
 
One fuse is for the lights and the other for the gauges.
The start is not fused.
Did you check the safety switch on the clutch?
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top