There was an old post on here where a member by the username of WI50 was offering to degree a cam if you sent him one. I am currently building a WD45 engine and had the cam reground, port and polished the heads, polished and cleaned up the manifold and would hate for all this work to be fore naught because the cam is off. My concern is that there does not seem to be a simple way to adjust the degrees of then skipping a whole tooth but from what I read there are ways of doing this. I am just not to this level yet and do not feel comfortable doing it myself.I guess I should ask if can even be done by just send out the cam or does it need to be done in the engine its going to be installed in. If anyone out there knows someone who can do this near centeral or southeast PA or knows someone who I can send it to please let me know.
Thanks,
Matt
Thanks,
Matt