wc input shaft seal

tallpa56 · Dec 24, 2015

After i pulled the motor on my wc that i bought, i noticed there was alot of oil and grease all in the bell housing, so i want to replace the seal around the shaft. I have found seals for the wd and wd45, but cant find one for the wc. Could someone please tell me where to get one and what is the best manual to buy, i am just learning about these allis chalmers. Thanks so much.

Aaron SEIA · Dec 24, 2015

I'd bet the rear main seal is the culprit. I&T manual is a good reference, but nothing beats the original AC service manuals.
AaronSEIA

JMS/.MN · Dec 24, 2015

I&T would be the AC11 version.

JoeM(GA) · Dec 24, 2015

I have a PDF of the Allis service manual you're welcome to, shoot me your email if wanted

Joe

Bob · Dec 25, 2015

Agco Parts On-line shows the seal # to be 70202086, 2 used.

Also, here's a link to a previous post by JoeM with more info...
Previous thread

tallpa56 · Dec 25, 2015

Thank you all for the help. Joe my email is [email protected]. thanks again

JoeM(GA) · Dec 25, 2015

it's on the way

wc input shaft seal

tallpa56

Member

Aaron SEIA

Well-known Member

JMS/.MN

Well-known Member

JoeM(GA)

Well-known Member

Bob

Well-known Member

tallpa56

Member

JoeM(GA)

Well-known Member

Similar threads