Hoenes
Member
I'm in the process of building a stationary power
unit out of a WD engine. I still need a bell
housing conversion unit though. It seems someone
on this site thought a lot of the bolt patterns
were the same. (125 / 201/ 226) I don't know, as
I still have the clutch on the engine. (I need to
make a template of the hole pattern). Does anyone
know about compatibility of any of these, or better
yet, where can I find one?
unit out of a WD engine. I still need a bell
housing conversion unit though. It seems someone
on this site thought a lot of the bolt patterns
were the same. (125 / 201/ 226) I don't know, as
I still have the clutch on the engine. (I need to
make a template of the hole pattern). Does anyone
know about compatibility of any of these, or better
yet, where can I find one?