(800) 853-2651
SHOP NOW

Allis C / Allis CA transmissions

Sure you can. I have a C with a CA transmission out back in my scrap yard. I plan using that transmission in one of my B's.
 
If you want hydraulics it all has to be from a CA including the pto/belt pully housing. Then if you want hydraulics you will not use the (normal) B or C bench seat.
 
The hydraulic pump is basically the same pump as the WC pump. I bought a non running CA with a Henderson loader mounted on it and it was hooked into the CA hydraulics. I took the loader off to repair the tractor but the loader still sets out in the scrap area and was never remounted to the tractor. I don't know how fast the loader lifted.
 
some of the CA rear lifts used two 1-1/2 inch cylinders... I would guess the front boom cylinders are comparable diameter and would be adequate for speed... Will not be too fast, but should work.
 
The hydraulic pump on a CA is a high pressure system the henderson loader was designed to operate on the Charlynn Combo pump. It is a low pressure system. its also fairly low flow so you will have average operating speed. but you can overpressure the loader rams.I use a Allischalmers modle 100 on my CA the loader works fast enough for mee the cylinders are about the size of henderson loader rams but much sturdier.
 
You must log in or register to reply here.

Similar threads

A
Allis c??
Replies
12
Views
811
olddavid
olddavid
D
ca air cleaner assembly
Replies
1
Views
549
JOCCO
J
D
ca engine serial number
Replies
2
Views
253
Aaron SEIA
A
J
Allis c and ca parts question
Replies
1
Views
341
Kip-Utah
K
A
Will the bench seat from a C fit a CA?
Replies
2
Views
556
atlarge54
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top