Anonymous-0
Well-known Member
have a few problems with my carb. Tractor was sitting at my brothers place for the last year, I asked to get it going if I could rake with it. the 1st time I took to carb apart and soaked it in drain cleaner. Then put a new float in it (old one was crushed) and a new kit. I put an in line filter on it, run good off to rake....
1) runs like sh!t, under load it stalls, then puffs black smoke, runs, stalls puffs, ect.
2)over flowing with gas out the side arm and into the air cleaner
went and put 2nd kit in it re adjusted float
no power, acting like it runing out of gas (good flow to plug)
opened it again re adjusted float witch is (smashed?)
now i have fuel running all over the place again
is there some thing i'm missing or beating a dead horse? every time to take it apart is 26 dollor kit.. why would the floats be smashed? any help please?
1) runs like sh!t, under load it stalls, then puffs black smoke, runs, stalls puffs, ect.
2)over flowing with gas out the side arm and into the air cleaner
went and put 2nd kit in it re adjusted float
no power, acting like it runing out of gas (good flow to plug)
opened it again re adjusted float witch is (smashed?)
now i have fuel running all over the place again
is there some thing i'm missing or beating a dead horse? every time to take it apart is 26 dollor kit.. why would the floats be smashed? any help please?