|Allis Chalmers Discussion Forum|
Re: Can i drill this out??
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
I would drill it, center punch it first, and heat the stud, till it's hot enough to melt a beeswax candle against it. Drill with about 1/8 pilot bit first, then go to the correct size LH bit for the stud. Usually they break loose, just as the bit breaks through the other side of the stud. If not, then you can try a spline type ez-out I like the blue-point ones. When you try the easy out, try tightening just a little, if you feel a slight movement, then reverse direction, and spray liberally with your favorite penetrating oil, and keep moving it forward and back. Eventually you can back it out most of the time. Don't break the easy out by using an impact, or too much torque. If it feels like it ain't moving, heat and wax, again, and walk away overnight, and try again.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters