WD wiring harness

red.green · Aug 3, 2012

I’m starting a rewire and repair on an Allis WD that someone has vandalized, sometime next week. I don’t want to spend a lot of time tracing what’s missing so it’s more cost effective to replace the whole harness My question is who has the best wiring harness for the buck?

old · Aug 3, 2012

Alternator as in 12 volts or a generator?? as in 6 volts. If 12 volts I do my own but if 6 volts I can not help you since I do not do them

Anonymous-0 · Aug 3, 2012

Steve at B&B Custom Circuits has the best. Just tell him what you need and he has it. They look very original and complete with instructions. 973-632-5596

red.green · Aug 3, 2012

Old, I can’t remember if it’s 6 or 12v customer said it’s the same tractor I did a bunch of work on last summer. I could make one myself as I’ve done that before, but my time is better used repairing the Mag and other items that were damaged. He can afford to repair it right as the tractor is supposedly going to auction in a couple weeks and should help with resale.

Aaron SEIA · Aug 3, 2012

X2 on B&B. He can also do the mag and carb if needed. First class work.
AaronSEIA

red.green · Aug 3, 2012

Thanks for the input, I do all my own magnetos and carburetors but there comes a point where my time is better spent doing what I do best. In the past I worked at an alternator shop where we did starters, alternators, magnetos and carburetors. Do to the pending auction I have to prioritize the work to ensure the completion of the tractor before the auction.

BushogPapa · Aug 3, 2012

Now, RED GREEN..we all KNOW that you have a fulL case of Duct Tape..so you ARE FULLY PREPARED TO REPAIR THAT WIRING HARNASS..!!!

Ron..

steve(ill) · Aug 3, 2012

well, if its a mag, you dont need many wires. Cable from battery to starter switch and your ready to go. If it is a distributor, you need a toggle switch with hot wire on one side and other goes to the coil, and coil out to the distributor point. About 30 minutes and your ready to go.

old · Aug 3, 2012

Shoot if it has a mag the wiring is very simple since it will not have any thing but a start circuit and then a charge circuit

old · Aug 3, 2012

Shoot if it has a mag the wiring is very simple since it will not have any thing but a start circuit and then a charge circuit

Allis Dave · Aug 6, 2012

The site store sells the engine harnass for about $75> I bought one last year. It's a good harnass it just doesn't have the original insulation or the light kit, but I think they sell the light kit separate.
Steiners sells a really nice combined engine and light kit with the original cloth insulation for around $150

WD wiring harness

red.green

Member

old

Well-known Member

Anonymous-0

Well-known Member

red.green

Member

Aaron SEIA

Well-known Member

red.green

Member

BushogPapa

Well-known Member

steve(ill)

Well-known Member

old

Well-known Member

old

Well-known Member

Allis Dave

Member

Similar threads