(800) 853-2651
SHOP NOW

Help with AC B

J

John 37A

Member
Hello.
The kids in our FFA chapter our working on the principal's AC B. We need to change out the tool boxes, as his is rusted badly around the bottom sides. How is is done? The steering rod runs through it. All the bolts are out of the panels, we just need to get it from around the steering rod. Any help is appreciated.

John
 
I can"t remember for sure but I was thinking that you just have to pull the steering arm off the box, take the throttle and choke cables off and the battery box then it slides up and off.
 
Proble easier to remove the steering wheel first, then the assuming you have already removed the gas tank, take the strap off at the top. If you loosen the bolts holding the steering box you can slip the tool box past the post. You can take the two bolts holding the steering box to the torque tube and remove it all together. After the gas tank is removed I put the torch over the threads on the torque tube down in the tool box and heat hot so the rusted screws do not twist off.
 
You must log in or register to reply here.

Similar threads

W
Series 420
Replies
12
Views
280
DoubleO7
DoubleO7
B
Anyone have a Speedex Model B? Looking for some measurem
Replies
0
Views
752
Brett Kelly
B
A
How to disassemble steering column (JD 4050)
Replies
2
Views
367
Arven
A
U
8n Steering box
Replies
7
Views
475
Tim PloughNman Daley RIP
T
S
Need a year model for Massey Ferguson
Replies
8
Views
466
Sarai7
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top