Plow jockey
New User
Have a 185 diesel, rebuilt the trans and rear end. Hydralics and power director work fine, but pto will not spin at all. Did I miss a coupling on pto shaft putting the two halves together?
- Thread starter Plow jockey
- Start date
Skyhighballoon(MO)
Member
- Location
- Pilot Grove, MO
Hydraulic PTO engagement? Check behind the battery box on the left side by the clutch pedal pivot. Should be a manual disconnect lever there for the sliding coupler to mate the front & rear PTO shafts. Mike
Plow jockey
New User
Yes it is hydralic clutch. Thanks I will check that manual disconect.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy