Posted by Jharn57600 on July 29, 2014 at 05:07:36 from (50.152.121.205):
In Reply to: Case 900 drawbar posted by kedin900 on July 28, 2014 at 11:39:15:
It pulls fairly well. I have the drawbar about as short as I can get it and still get 20" of height below the PTO housing. Even with it short I still usually have to stack a bunch of weight on the front to keep the front end down in the 9500 lb class. If you are pulling sleds with a long chain you may want to have the ability to move the drawbar out some. I made my front drawbar mount so that with one bolt I can remove the pin and slide the drawbar longer or shorter to a different hole or replace it with the stock length bar for farming.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.