Posted by Case-O-Man on February 19, 2013 at 12:43:52 from (207.28.7.253):
I am looking for some posible causes for why my pto will not hold adjustment. I have tightened the pto cluch twice now the first time I was going to use it on a corn picker and it wouldn't even turn anything over I had used it to unload a few silage wagons before and it seamed to work fine. I adjusted the cluch so it took pleanty of preasure to engauge with the lever. The next time I was able to use the tractor was hauling manure, I got half way unloaded and disengauged the pto to turn around and when I went to engage it again it was lose and wouldn't run the spreader. I adjusted the pto again thinking maby the adjusting pin didn't lock in place, the second time i made sure it was sprung back in all the way, I was also carful not to realese the cluch veary fast but after awhile it losend up again. It is an 831 and has the counterclockwise (looking from the back) tightening cluch. Any help is greatly apreteated. Thanks. Austin
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
