Posted by kycase1 on February 01, 2013 at 15:14:57 from (74.50.33.197):
IT has been some time sense I have posted, so I will start by saying Hi and hope everybody is doing well. All the pictures are great (Nutty and others).I had the priviledge of getting to spend a few hours visiting Nick@Ky and looking over his collection of case tractors and equipment. I learned alot about my VAI and VAC. (Thanks Nick). Now for the question for the case experts,I was looking through my VAI parts catalog and noticed in the sheet metal section that it showed side engine covers. Part numbers VTA-2770 right-hand and VTA-2771 left-hand. I have never seen a VAI or any other VA series tractor with these engine covers. Were these a seldom used opition or just the first thing to get tossed to the wayside when it came time to work on the engine? Does anyone have a picture of a tractor with these engine covers installed? I would love to see it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.