Posted by denverslim on January 15, 2013 at 16:15:27 from (22.214.171.124):
Ok you Casers.
This is on a recently acquired tractor that I have no history on.
The seal around my PTO shaft is leaky. Some kind of soft rubber or cork around metal. How does it come out. I tried pulling the entire plate out but it seems to be attached to the shaft somehow. It won"t come off. Looking at the book it looks like some special tools may be required to take off the shaft, and I hate to do this just to remove this seal. Can I remove the seal from the outside by just destroying it and then put a new one on with a ball-ping hammer? Or does it have to be installed from the inside?
Also, I notice that I can"t easily turn my pto shaft. It requires a pipe wrench to turn it with considerable ummph. I have the pto lever un-engaged. Have I got BIG problems?...slim
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.