Posted by 4435 on January 14, 2013 at 16:48:56 from (220.127.116.11):
In Reply to: hydralic cylinder posted by mike plotner on January 14, 2013 at 08:20:05:
Bradley, A little history as I know it. Had an Uncle worked in Wichita at Cessna (must been a pretty savvy guy) died In1972. Cessna made a run of cylinders for Case, For some reason they didn't work or work right so they went to the scrap heap, the engineers couldn't figure the problem out so I was told. Uncle Glen asked for a couple of them, snuck them back inside and fixed the problem. I can remember Dad had one on the 3-14 AW plow he pulled with the DC it was a 4 inch. When Dad traded the DC in on the 730 the dealer knew the story and swapped him a brand new cylinder for the old 4 inch.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.