Posted by Nedd on January 03, 2013 at 17:38:50 from (220.127.116.11):
In Reply to: Re: mn1200TK posted by 1370rod on January 03, 2013 at 16:55:15:
I think that exhaust manifold was also used on early 930's but had another connecting bracket for the actual exhaust pipe. On the 1200's isn't there a plate connecting the two to the turbo. Never looked at them that close but sure looks like the early manifolds. Hopefully I got this picture to load. It is from the photos here on the board. Look at this exhaust. It is centered not up front like the later ones. Rod email is open would like info on the turbo if there are no other takers.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.