Posted by clint goethe on January 02, 2013 at 20:26:11 from (64.53.104.30):
I HAVE A CASE 1570 THAT HAS 2000 PSI AT REMOTES BUT WONT PICK UP THE IMPLEMENT.THE TRACTOR SHIFTS AND PULLS FINE IN ALL THE RANGES AND GEARS IN THE POWERSHIFT.THE PTO WORKS AND ALSO THE 3PH ALSO WORKS AS I HAVE BEEN PULLING A 3PH CHISEL PLOW WITH IT.THE PRESSURE AT THE REMOTES IS 1000 PSI IDLING AND 2000 AT FULL ENGINE RPM.THE PRESUURE ALSO STAYS THE SAME AT REMOTES AS I SHIFT THREW ALL 3 GEAR ON THE TRANS.I THINK I MAY HAVE A PROBLEM ON THE REMOTE HYDRAULIC VALE RELIEF VALVE,I NEED SOME GUIDANCE.THANKS GUYS.I HAVE FLOW FROM REMOTES WHILE RUNNING OIL INTO A BUCKET.PLEADE HRLP ME TAKE A STEP FORWARD
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.