Posted by mEl on November 10, 2012 at 17:59:39 from (220.127.116.11):
In Reply to: 970 or 1070 posted by ed pick on November 10, 2012 at 04:59:21:
Quoting Removed, click Modern View to see
ACG, I'm sure that what was meant was that the later were easier due to the RPS being accessable through the bell opening without removing the valve and top cover. Once the C1-C4 feed tubes are removed the carrier can be removed and the RPS simply slid off the RPS output shaft. There were a couple serial number breaks but all were simpler than the original design. 10-4 on the platform clearance issues on the 7-8s a real pain to get the cover in and out. Picking the cover up far enough to fold the forks up into the cover usually gained the needed clearance.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.