Posted by theljam on November 03, 2012 at 23:32:00 from (22.214.171.124):
In Reply to: c case 1929 posted by jerry m 3 on November 03, 2012 at 14:04:08:
Jack up the wheel you want to remove and block the tractor so it's safe. You will find two drilled and tapped 3/4" holes in the hub on each side of the axle. Make sure the holes are clean by running a tap through them. Next you need to drill two 3/4"+ holes in a heavy piece of steel about 2" thick spaced the same distance apart as the holes in the hub. Remove the cotter pin and castle nut that holds the hub on the axle. Place the piece of steel with that two holes flat against the end of the axle and thread two 3/4" bolts through the drilled holes and into the holes in the hub. Tighten the two bolts tight and hit the steel plate with a sledge hammer in the middle where it meets the axle on the other side. The wheel and hub should break loose from the axle. If not try tightening the bolt some more and hitting it again. The axle is tapered and has a key, if it has never been off it may take some serious tightening of the bolts to get it to pop loose. Good luck.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.