I knew that all I had to do was put "Case" and "inferior" in the same paragraph to get some good conversation going. ;) Thank you all for coming to Abe's defense. That's all good info. I think I'd still take a rocking front bolster over solid, but it may depend highly on the job and the bed. I've seen plenty of rocking bolsters and literature for other brands that shows them, but I haven"t seen an older Case or Case literature that shows them. So, I don't know that Case had it as an option (at least not before the more modern equipment of the '60s and '70s.) When we threshed this year, we had to borrow several racks, which added a fair bit of time before and after. We have one on a JD gear and another on a homemade gear. We also have my great-grandpa's IH gear on steel that we could build a rack for, but I'd like to find a Case gear too (ideally on steel). That would make 4. I'll keep my eyes open, and may try that chaining idea.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.